- Extremely High Rate Capability
- High safety performance(no flowing electrolyte)
- Fast charging is available(can up to 3C, less than 20minutes)
- Very good performance under high temperature
- High energy density, 110~140wh/Kg
- Light weight and small volume, about 1/3 weight and volume of lead-acid batteries
400KW Lithium Battery Energy Storage System
Geepower® 400KW*1h energy storage system is assembled with a 400KW battery system, combiner box. All of these equipments assembled in a standard 20-foot container, include Fire services equipments, smoke alarm equipments, grounding-products and Heat management system. Lithium batteries in the system support 1.5~2C continuous charge and discharge, tolerant ranges of temperature is -20℃～65℃.
400KWh storage system be assembled by 4packs 537.6V 200AH LiFePO4 batteries in series and parallels. Each pack energy is 107.5KW, 4pcs packs in parallel, total energy can up to 430KW.(Each 437.6V 200AH LiFePO4 battery pack is assembled with 168pcs 3.2v 200AH LiFePO4 battery module.)
GeePower®3.2V 200AH LiFePO4 lithium high power battery pack can be used to Electric vehicles and other energy storage areas. These Lithium Iron Phosphate (LiFePO4) batteries, produced by GeePower here in China, are rated at more than 2000 recharge cycles, can be assembled in series and parallel with a battery management system (BMS).
All of the batteries and BMS be installed on a shelf with protective screening.
107.5KW Battery System Main Feature
Each 6pcs 3.2V 200AH battery modules as a small pack, packing in a box, the box with handles, be convenient for transportation and install(picture as below).
Install smoke alarm equipments in each 20-foot container, can be monitored and alarmed by monitoring equipments. Each container both install fire-fighting equipment, such as dry powder extinguisher,Automatic pneumatic fire extinguisher, Fire isolation door. When the fire happened, electric isolation, spatial isolation will be started automatically.
Each 107.5Kw storage system be protected by a battery management system,include 7pcs data acquisition module, 1pc main controller, 1pc Insulation monitoring module, 1pc 500A Hall sensor, 1pc LCD display and High pressure control device. Battery working condition can be showed on the built-in LCD display, also can be transferred to SCADA for monitoring and controlling. Communication protocol is ModBus, communication mediums is RS485.
BMS will be assembled as 3 floors architecture, the first floor working for battery cells data collection; the second floor working for battery pack data assembling and high pressure control; the third floor working for communication with BMS and remote control. This floor mainly collect all of the battery data,coordinate all of the working between battery contactors.
400KW Lithium Battery Energy Storage System 16S 800Ah Parameters
|Place of Origin||China (Mainland)|
|Nominal Voltage||537.6V(168 cells in series)|
|Rated Capacity||800AH(4 cells in parallel)|
|Rated Charge Current(0.3C)||240A|
|Rated Discharge Current(1C)||800A|
|Max. Charge Current(0.6C)||480A|
|Max. Continuous Discharge Current(1.5C)||1200A|
|Max. Continuous Output||0.645MW|
|Storage temperature||Less than 3 mouths:-10℃～45℃|
|Less than 1 year: -10℃～25℃|
|Describe the working conditions||Normal charge and discharge cycle
Every day can be charge and discharge
|Deep Cycle charge and discharge cycle
Once every three mouths(monitoring system send maintain signal out)
• The 400KW Lithium Battery Energy Storage System max continuous discharging current is 1200Amps, peak discharge power is 645Kw.
• Power Supply Voltage for the 400kw storage system is AC220V, internal system power supply is DC24V(through AC-to-DC transfer).
• Heat management: With a 5P air conditioner to control the container’s inner temperature, also install ventilation device to form internal circulation, in order to make sure temperature in each corner of container are the same.
• Storage container installing form: on the ground.
• Lightning protection: container box connect with ground directly, welding bolt onto the container outside. All use Special grounding products (model:ZLM-2), lifespan can be 30years. The bolts are choose non-metallic conductive materials as main part, Low conductivity, stable performance. Buried in the soil, non-degradable, No corrosive ions, long lifespan, security and eco-friendly.
400KW Lithium Battery Energy Storage System BMS Parameters
|Assembly||168pcs 200AH in series, 4pcs in parallel|
|Battery Pack Nominal Voltage||537.6V/Pack|
|Battery Configuration||672pcs 3.2V 200AH LiFePO4 Battery Modules|
|BMS IP Code||IP40|
|BMS Electrical Device||Voltage test wires, temperature sensor, contactor, current sensor, temperature control relay and other Communication device.|
|Power supply for BMS||220VAC power supplier(BMS operating voltage 24V/100W)|
|Single cell sampling precision||±10mV|
|Single cell sampling frequency||≤100ms|
|Temperature sampling number||3pcs|
|Temperature detection accuracy||≤±1℃|
|Temperature testing cycle||≤1S|
|LCD display||7” LCD|
|Current detection accuracy||≤0.5%FSR|
|Current detection cycle||≤100ms|
|SOC Estimation accuracy||≤8%|
|communications protocol||CAN or RS485|
3.2V 200AH Battery Energy Storage System Detailed Image
|C||Tab center distance(C)||80.0±1.0|
Get in Touch
More info about our company and our batteries, please feel free to contact with us, our team is ready to support you.
Phone: +86-769-85373696 or +86-769-85373969